Stats

Locked Locked
Replies 2
Subscribers 143
Views 15347
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Annotate DC operating point in Schematic (incl subcircuits) after simulation

Hi,

I am using ADE-L to run simulations (using simulator: eldo). When I run a DC simulation, the DC operating points are nicely annotated at the toplevel, but not in any of the subcircuits (down the hierarchy). I have searched for various options, but could not find any flag to make that happen.

Any help would be appreciated.

Thanks and Regards,

Atul.

Parents

Atul Dwivedi over 10 years ago

Thank you Andrew for the reply.

I updated to the latest version: 6.1.6, but still I cannot see any improvement.

I will contact Mentor now.

Regards,

Atul.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Atul Dwivedi over 10 years ago

Thank you Andrew for the reply.

I updated to the latest version: 6.1.6, but still I cannot see any improvement.

I will contact Mentor now.

Regards,

Atul.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.