Stats

  • Locked Locked
  • Replies 7
  • Subscribers 144
  • Views 16128
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multipart Path (MPP) Bends with Separated Sub-Rectangles

resngc

Hi!

I am using the multipartPathTemplates SKILL function to construct a MPP consisting of sub-rectangles that are created along a sub-path separated some distance from the master (central) path. The issue is that when an instance of the MPP is created and bent at 90 degrees, there is a gap in sub-rectangle placement around the bend that is larger the further the sub-rectangles are spaced from the master path; essentially no sub-rectangles are populated in the corner region where the bend occurs. This is, in part, because the n_beginSegmentOffset argument defines the relative spacing between the sub-rectangle and the master path, following the new path segment after each bend, and is therefore being supplied with a value large enough to keep all the sub-rectangles spaced evenly apart from one another and aligned properly with other sub-rectangle paths in the MPP structure. Does there exist a way to define sub-rectangle positioning relative to its own path, or sub-path, as opposed to the master path? Is there any known approach to filling in the gaps around bends such that the sub-rectangles maintain their spacing and alignment about these separated paths? Perhaps some lower level SKILL or ROD functions are necessary to achieve this? Again, this issue is present only when the sub-rectangles are spaced apart from (i.e. not coincident with) the master path. If the problem description is unclear please let me know and I will provide a crude illustration highlighting the concept.

Relevant documentation (Cadence Online Support --> Product Pages): Virtuoso Technology Data ASCII Files Reference Product Version 6.1.6 June 2015; see section on multipartPathTemplates

 

Any help is greatly appreciated!

Parents

  • Hi Ryan,

    I think that this is a bug you should probably file it with Cadence - I encountered something similar with subrects when I was trying to define a double-guardring like structure.  One workaround approach would be to define the subpath as a separate MPP and use an enterFunction to gather points and draw the two or more MPPs using the points gathered.  You'd probably have to do a bit of mathematics with the points to give the appropriate offsets.  You could also calculate all of the shapes yourself, which would be a ton of work ;-)

    Hopefully this might help a little?

    Regards,

    Lawrence.

Reply

  • Hi Ryan,

    I think that this is a bug you should probably file it with Cadence - I encountered something similar with subrects when I was trying to define a double-guardring like structure.  One workaround approach would be to define the subpath as a separate MPP and use an enterFunction to gather points and draw the two or more MPPs using the points gathered.  You'd probably have to do a bit of mathematics with the points to give the appropriate offsets.  You could also calculate all of the shapes yourself, which would be a ton of work ;-)

    Hopefully this might help a little?

    Regards,

    Lawrence.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.