Stats

  • Locked Locked
  • Replies 4
  • Subscribers 143
  • Views 1721
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Create an alternative pmos/nmos pcell, with all virtuoso functionality

RVERP

Hi,

I want to replace the nmos/pmos of the fab with an alternative pcell I have created myself.

This custom pcell uses the mos pcell, and adds things depending on the parameters I have added. Now I want to use this custom pcell in my layouts, but I also want to use the virtuoso functionality

I should be able to:

  1. Do a gen form source. The new pcell must be used.
  2. Maintain the connectivity.

Things I have so for:

  1. Gen form source: I have changed the physical cell in the physconfig. The gen from source picks the custom cell I want, but the parameters set in the schematic aren't transferred correctly to the new pcell. I have changed my custom pcell so that the names are the same as the ones I see in the cdf.
    Now if I do a gen from source, parrameters are filled in, but the numbers filled in are float (1e5), while in cdf they are a string (10u).
    QUESTION: How are parrameters tranfered to the pcell in a gen from source. Are the always passed as a float? Does this happen in a standard way or is this dependant of the techno?
  2. Maintain connectivity: I suppose adding pins/terminals is enough here. Only I have to have the naming right.
    QUESTION: Is it oke to suppose that these are s d g b by default?

I hope the above description is a bit clear, if not, I am happy to clarify is some more.

Parents

  • What are the parameters on the source component in the schematic? Are these float too?

    Adding pins/terminals will be needed. You'll need to call them whatever they are called on the source device. There's no "default" naming for them - it purely depends on what the source device has called them.

    Regards,

    Andrew

Reply

  • What are the parameters on the source component in the schematic? Are these float too?

    Adding pins/terminals will be needed. You'll need to call them whatever they are called on the source device. There's no "default" naming for them - it purely depends on what the source device has called them.

    Regards,

    Andrew

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.