Stats

  • Locked Locked
  • Replies 2
  • Subscribers 143
  • Views 13836
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to ignore number of finger comparison while running LVS.

GirishBS181

Hi,

I am using Assura for LVS. I am getting parameter error because i have not maintained the number of fingers same as in schematic.

I want to ignore the number of finger comparison & i want the tool to compare only the total width. The only way i am able to do this is by manually editing schematic & changing the width to total width.

I am presently working on 500nm node & usually there used to be a switch in assura called "SKIP_MOS_MI_COMPARE" when working on other nodes which is not there in 500nm.

Below are the switches presently available in LVS FORM.

HPO2RES_1K

HPO2RES_2K

HPO2RES_3K

MOM_2T

MOS_D/S_TO_PW/GD_CHECK

NON_ZERO_DELTAW_DELTAL

RES_T3

THICK_TOP_METAL_3UM

WELL_TO_PW/GD_CHECK

Is there any other way where in i can ignore the number of fingers & compare only the total width.

Thanks,

Girish

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.