Stats

  • Locked Locked
  • Replies 3
  • Subscribers 144
  • Views 14220
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

interactive creation of rod path

drdanmc

I know how to create a path with rodCreatePath() which gives some flexibility in terms of programming the type of path.  For example a bus of varying bit width, metal width, spacing, layer, etc.  However it stinks for interactive use.  I can easily draw a MPP interactively but my selection is from a limited set of paths I've pre-defined.  Is there a simple way to combine them?   Basically is there something like rodCreatePath where I can use a path I've defined via skill (possibly from inputs in a custom dialog) but draw the path interactively?

Thanks

-Dan

 

Parents
  • Hi Quek,

    Thanks for the pointer to that solution. That actually helps with something else I've wanted in the past but it is actually not quite what I was looking for here.

    That solution lets me use skill to draw a MPP which has been defined in the tech file. What I'm looking for is a way to interactively draw a rod path which has been created on the fly as opposed to defining a MPP template. There is leHiCreatePath() for interactively creating a path. I'd like a leHiCreateRodPath() where I pass in the layer, width, offsetSubPath, etc.

    There seems to be an undocumented leHiCreateMPP so maybe I could make a template on the fly, call leHiCreateMPP, and then delete the template but that seems like a real hack and I'm not sure I even can delete a template.

    -Dan
Reply
  • Hi Quek,

    Thanks for the pointer to that solution. That actually helps with something else I've wanted in the past but it is actually not quite what I was looking for here.

    That solution lets me use skill to draw a MPP which has been defined in the tech file. What I'm looking for is a way to interactively draw a rod path which has been created on the fly as opposed to defining a MPP template. There is leHiCreatePath() for interactively creating a path. I'd like a leHiCreateRodPath() where I pass in the layer, width, offsetSubPath, etc.

    There seems to be an undocumented leHiCreateMPP so maybe I could make a template on the fly, call leHiCreateMPP, and then delete the template but that seems like a real hack and I'm not sure I even can delete a template.

    -Dan
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.