Stats

  • Locked Locked
  • Replies 3
  • Subscribers 144
  • Views 14220
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

interactive creation of rod path

drdanmc

I know how to create a path with rodCreatePath() which gives some flexibility in terms of programming the type of path.  For example a bus of varying bit width, metal width, spacing, layer, etc.  However it stinks for interactive use.  I can easily draw a MPP interactively but my selection is from a limited set of paths I've pre-defined.  Is there a simple way to combine them?   Basically is there something like rodCreatePath where I can use a path I've defined via skill (possibly from inputs in a custom dialog) but draw the path interactively?

Thanks

-Dan

 

Parents

  • Hi Dan,

    The leHiCreateMPP function is actually public, but not documented for some long-forgotten reason. So I filed a CCR on your behalf to get it documented.

    Anyway, you could either use this in a slightly convoluted way, or use enterPath() to create your own user interface to digitise the master path, and then use rodCreatePath() to create the MPP from the points entered. You could have an options form on the enterPath to allow you to enter the width and so on via an F3-options form.

    I'm sure there are solutions for this (and maybe on this forum - I suspect if  you search (using the magnifying glass in the top right corner of this page) for rodCreatePath enterPath you should find a few bits of code...

    Regards,

    Andrew. 

Reply

  • Hi Dan,

    The leHiCreateMPP function is actually public, but not documented for some long-forgotten reason. So I filed a CCR on your behalf to get it documented.

    Anyway, you could either use this in a slightly convoluted way, or use enterPath() to create your own user interface to digitise the master path, and then use rodCreatePath() to create the MPP from the points entered. You could have an options form on the enterPath to allow you to enter the width and so on via an F3-options form.

    I'm sure there are solutions for this (and maybe on this forum - I suspect if  you search (using the magnifying glass in the top right corner of this page) for rodCreatePath enterPath you should find a few bits of code...

    Regards,

    Andrew. 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.