Stats

  • Locked Locked
  • Replies 3
  • Subscribers 143
  • Views 14245
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Opening existing layout from schematic in XL using SKILL language

SKILL

Hi,

I have done the layout of a particular schematic and in my case schematic and layout are present in different library.

I need the solution for opening the existing layout from schematic using SKILL.

Thanks in Advance!!

Regards,

Srimant

Parents

  • Hi Srimant,

    You might consider the following then, which sets the connectivity reference for the layout cellview using SKILL:

    lxSetConnRef( 
      t_layLib 
      t_layCell
      t_layView 
      t_sourceType { CELLVIEW | NONE }
      [ ?schLib t_schLib ]
      [ ?schCell t_schCell ]
      [ ?schView t_schView ]
    )
     => t / nil

    
Sets or unsets the connectivity reference for a specified layout cellview without opening the layout view graphically. You must specify the layout view and whether the source type is NONE or CELLVIEW. If the source type is CELLVIEW, you can specify the schematic cellview to use (by default it is set to the schematic view in the same library and cell). The function also saves the layout cellview, but only if had not been modified prior to lxSetConnRef being called.

    Hopefully this is what you are looking for, or at least helpful.

    Best regards,

    Lawrence.

Reply

  • Hi Srimant,

    You might consider the following then, which sets the connectivity reference for the layout cellview using SKILL:

    lxSetConnRef( 
      t_layLib 
      t_layCell
      t_layView 
      t_sourceType { CELLVIEW | NONE }
      [ ?schLib t_schLib ]
      [ ?schCell t_schCell ]
      [ ?schView t_schView ]
    )
     => t / nil

    
Sets or unsets the connectivity reference for a specified layout cellview without opening the layout view graphically. You must specify the layout view and whether the source type is NONE or CELLVIEW. If the source type is CELLVIEW, you can specify the schematic cellview to use (by default it is set to the schematic view in the same library and cell). The function also saves the layout cellview, but only if had not been modified prior to lxSetConnRef being called.

    Hopefully this is what you are looking for, or at least helpful.

    Best regards,

    Lawrence.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.