Stats

  • Locked Locked
  • Replies 1
  • Subscribers 144
  • Views 14504
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to use auto-abutment in custom Pcells

RVERP

Hello,

Can somebody tell me how the auto-abutment works, and how to introduce it into my own Pcells?

Thanks

  • Hello RVERP,

    I would begin by reading the  Virtuoso Layout Suite XL User Guide , Chapter 5,  Device Abutment.   Then I would give it a go on my own.

    When (not "if") I needed to debug further, I'd check out the  Virtuoso Parameterized Cell Reference , Chapter 7,  Debugging SKILL Pcells , paying particular attention to the information about debugging abutment.

    Good luck,

      --tom

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.