Stats

Locked Locked
Replies 1
Subscribers 144
Views 16575
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Skipping symbol mismatch during check and save of schematic views

Hello,

When i save a schematic view, if there are any pin mismatch with the symbol view, GUI will give a warning that there is a symbol mismatch and whether to update symbol or not.

Using SKILL will I be able to skip these symbol cross checking? Also how to save a schematic without updating the symbol?

One more doubt is, I can see many views with names like schematic_model (schematic_*) . What is the significance of these views.

Parents

mschw over 7 years ago

Hello,

you can disable the Cross View Checks in the Schematic Editor -> Menu Item "Check" -> Item "Cross View" and set the Cross View Check Severity to ignore.

Kind regards,

Matthias
Cancel
Vote Up 0 Vote Down

Cancel

Reply

mschw over 7 years ago

Hello,

you can disable the Cross View Checks in the Schematic Editor -> Menu Item "Check" -> Item "Cross View" and set the Cross View Check Severity to ignore.

Kind regards,

Matthias
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.