Stats

Locked Locked
Replies 1
Subscribers 143
Views 15854
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Calibre Parasitic Extraction (Calibre PEX )error

Hello,

I would like to run the post layout simulation to check how good my layout is by using the IBM PDK caliber PEX and I am running into the following attached error.

Cadence Virtuoso version IC6.1.7-64b.500.12

I have contacted the customer support with GF (former IBM). At the same time, I would like to know how to solve this issue.

My Calibre Version is v2015.3_25.16. I was able to run drc, and lvs on the same design without no issues.

Thank you so much in advance.

Andrew Beckett over 6 years ago

Er, Calibre is a product from Mentor Siemens (not Cadence) and so you would almost certainly be better off asking this on a Mentor forum - or waiting for a response from GF since it's their rule deck.

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.