Stats

  • Locked Locked
  • Replies 2
  • Subscribers 142
  • Views 2329
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to generate input.scs from maestro view by SKILL backgroud?

Zest

Hi

I want to auto generate series input.scs netlists from series maestro views,  then use the netlists to do series EMIR analyses,

and all the actions above need to be done under batch mode (backgroud / -nogui way)

I found the nearest fit API is 'maeRunSimulation()' , it can generate input.scs I want but it has no 'without simulation' option

Is there some way/SkillAPI to generate input.scs without simualtion?

THX !

Parents
  • Andrew Beckett

    Not sure why you can't just run the EMIR simulations from the maeRunSimulation() calls?

    As far as I know, there's no way to just generate the netlist(s). Part of the reason is that maeRunSimulation may run many simulations if you have corners or sweeps set up, so there is no single netlist. Often that netlist is generated as part of the step immediately before simulation, and ADE Explorer/Assembler itself doesn't have an option to just generate the netlists for each point but not run the simulation.

    Regards,

    Andrew.

Reply
  • Andrew Beckett

    Not sure why you can't just run the EMIR simulations from the maeRunSimulation() calls?

    As far as I know, there's no way to just generate the netlist(s). Part of the reason is that maeRunSimulation may run many simulations if you have corners or sweeps set up, so there is no single netlist. Often that netlist is generated as part of the step immediately before simulation, and ADE Explorer/Assembler itself doesn't have an option to just generate the netlists for each point but not run the simulation.

    Regards,

    Andrew.

Children
  • Zest
    in reply to Andrew Beckett

    Hi Andrew

    The reason why I can't just run the EMIR simulations from the maeRunSimulation() calls is that there are two EDA tools refered, NOT all in virtuoso

    Current EMIR flow:

    1. Export input.scs from a maestro bench(virtuoso platform, using only one corner, mostly FF for worst case)

    2. Import the input.scs to relstudio(ansys platform) for EMIR analyse

    They are step-by-step proceed in GUI mode which makes low efficient, so I try to do this in bash skill  Slight smile

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.