Stats

Locked Locked
Replies 0
Subscribers 143
Views 12809
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Assura probing through Skill

I have a design where I would like to probe some nets. I can load the run and probe nets in the design with the Assura Probing tool. I was wondering if this form calls SKILL commands to perform the probe or is there much more going on than I realize. I have searched the Assura manuals and some Skill manuals but have not found a straightforward way to script the probe. I would like to automate a way to probe a set of signals without the need to enter them one by one in the form. Any help would be greatly appreciated.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.