Stats

Locked Locked
Replies 1
Subscribers 143
Views 14178
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to set path to simulation-files in ADE ASSEMBLER using asi-command ?

I'm looking for a way to set the path to simulation-files/definition-files in ADE ASSEMBLER via an asi-command.
So instead of interactively doing "Setup -> Simulations files" in a test in ADE Explorer and then filling out the form,
I want to do the same in batch-mode without opening the GUI. I found "asiGetDefinitionFileList" and "asiGetTextStimulusFileList",
but I did find anything like "asiSetDefinitionFileList".
Regards, Holger

Holger Wetter over 5 years ago

Found it:
asiSetEnvOptionVal(testSession 'definitionFiles list("./myFile"))
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.