Stats

  • Locked Locked
  • Replies 2
  • Subscribers 143
  • Views 13383
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change Label Purpose from Drawing to Pin

JWMP

Hi,

I have generated a layout using Innovus. Once I transfer it into Virtuoso, all the labels that are created have the Purpose of "drawing." In order for the Calibre LVS to pass, these labels need to have the Purpose of "pin." For large designs, I would like to avoid manually changing each label and was wondering if there are any SKILL scripts that I can reference to change each label Purpose from "drawing" to "pin." Hopefully, this question has not been asked before. 

Regards.

Parents
  • Andrew Beckett

    Rather than writing SKILL code, could you use Tools->Find/Replace and then search for labels, pick the layer they are on as a criteria, and then replace the layer to be the pin purpose?

    Andrew.

Reply
  • Andrew Beckett

    Rather than writing SKILL code, could you use Tools->Find/Replace and then search for labels, pick the layer they are on as a criteria, and then replace the layer to be the pin purpose?

    Andrew.

Children
  • JWMP
    in reply to Andrew Beckett

    Hi Andrew,

    Yes, that works! Thank you very much. 

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.