calculator numconv function

sorry, when ı send my plot to calculator

I think you should use the analog to digital functions that were referenced in the other thread you posted in after this. The numConv is really for single valued text numbers and will convert them into a different number base. I don't think it's the right solution here.

Andrew

ok. I found it

I'm glad you found it. Hitting help on the form makes it pretty clear, and to be honest you could experiment in less time than it took you to post the question.

Sır, my psd graph have infinity noise at the minimum level. İ can not get power spectrum density as in the like Matlab simulation. İ think that it is because of number of sample. İnput is 32 bit with 100 MHz clk frequency. But i can simulate it short time about 10u. İ don't have chance to run it long because of server. U have any idea about this problem

Please don't ask this new question on the end of the old thread (the forum guidelines ask you not to do this).

So please post a new question, with sufficient information that others can help you (I don't know where to start from your question above, since there's absolutely not enough information to understand what you're doing or what might be wrong, if anything). Perhaps somebody else will be able to figure out what you meant.

Andrew

Sır, dıgıtal bıts are converted to analog bıts, wrongly. For example, digital bit '4' is converted to 226mv and  bit '-1' is converted to 336mv. I dont understand

Why negative decimals dont take a negative voltage

abdurrahman0234 said:

Sır, dıgıtal bıts are converted to analog bıts, wrongly. For example, digital bit '4' is converted to 226mv and  bit '-1' is converted to 336mv. I dont understand

I don't understand either, mainly because you've posted on the end of an old thread (you had this working before, so I presume it's something different) and you've not provided any supporting information - such as a graph of the results, what you entered on the form, and so on. I can't read your mind!

Andrew

when ı converted  digital bits to analog bits, ıt takes decimals wrongly for the voltage output. For example, '-1' digital bit should be 840mv or else '-2' decimal should be at the minumum level but graph show not coorect

analog bıts shows not correct for the digital bits.Hı:3360m li:-840m X=(Xİ + Lİ)/2

analog bıts shows not correct for the digital bits.Hı:3360m li:-840m X=(Xİ + Lİ)/2