Stats

  • Locked Locked
  • Replies 0
  • Subscribers 143
  • Views 9773
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how to open xterm and start running job using ipcbeginprocess

saurabh96

Hey there,
is there any way to run the process in my xterm using ipcbeginprocess.. lemme me elaborate on that when I press run in my GUI...it should automatically opens x-term and starts running the process in that xterm(user shell environment), not in the cadence environment.


I am using below code..


ipcSkillProcess("xterm -ls -hold -e \"/pkg/check/2021.04.30/bin/version\" -parentTool virtuoso")


its opening xterm and putting error:- ERROR: requires Tcl 8.5 or higher.


and when I am running same process through my shell window process is running fine and smooth...I doubt when running through virtuoso, its not taking user shell env.

virtuoso tool is 6.1.7-64b version 


How to correct it..pls guide me!
Regards,
SRV

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.