Stats

Locked Locked
Replies 1
Subscribers 143
Views 1602
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to rerun unfinished/error simulation points with SKILL

YutaoLiu over 3 years ago

Hi all,

I am using version ICADVM20.1-64b.500.25.

I am exploring how to run a large number simulations with SKILL script as shown below.

I am going to run simulation on a clock buffer with multiple PVT combinations and then extract the result.

However, I find that a fraction of simulations were unfinished.

Is there any SKILL command (a single command or a set of commands) can realize equivalent functions as "rerun unfinished/error simulation points" in Maestro.

Thanks and regards,

Yutao

Andrew Beckett over 3 years ago

Yutao,

I'm not aware of a function to do this. You should contact customer support.

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.