Stats

Locked Locked
Replies 2
Subscribers 143
Views 772
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Assign of pwr/gnd sensitivity to bus pins by skill

Aldo3 over 1 year ago

Hello,

Is it possible to assign pwr/gnd sensitivity to bus pins using skill?

Thank you for your help

Best regards

Aldo

Parents

Andrew Beckett over 1 year ago

See What is the purpose of Supply Sensitivity on Add Pin form? How to get and set the power and ground sensitivity of a schematic pin or terminal using skill.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 1 year ago

See What is the purpose of Supply Sensitivity on Add Pin form? How to get and set the power and ground sensitivity of a schematic pin or terminal using skill.
Cancel
Vote Up 0 Vote Down

Cancel

Children

Aldo3 over 1 year ago in reply to Andrew Beckett

Thank you very much Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.