Does anyone know why on the Physical Contraint Set Sheet you are able to see all the nets including power or nets who's name starts with a number, and when you go to the Electrical Constraint Set Sheet (routing) you can not see the power nets only the normal signal nets,
I was trying to set a constraint for maximum exposure and number of vias, but that can only be done on the electric part of constraint manager.
Does anyone know if I have an extra setting or what could be going on?
Electrical constraints typically do not make sense for DC Nets. By design, DC Nets (any net tagged with a Voltage property) do not appear in the Electrical domain. If you wish to constrain the net as you describe, remove the Voltage property.
thanks a lot Dennis,
will try =)