I have a problem while doing the routing. Attched the snap shot. If i reroute the net problem sloved. is there any easy way to slove this problem. I am using allegro 16.3
The reason you get these Connect Point Markers (setup - Design Parameters - Display tab for size) is because some part of the net is part of a Replciate Module and the connect point marker shows where this join is. You can either hover of the module and RMB - Disband Group or ignore it (or reduce the size). It doesn't affect the connection.
Thanks for the reply. Can you guide me how to disband the group?
Make sure you are in Placement Application Mode (Setup - Application Mode - Placement Edit) then hover over the parts (use the tab to cycle what you have selected until the whole module is highlighted, then RMB (right mouse button) Disband group....