Stats

  • Locked Locked
  • Replies 5
  • Subscribers 165
  • Views 15502
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Copper Pours

Brian Rocks

I am still a noob when it comes to the PCB portion of Orcad.  I have a 4 layer board and am ready to make the pours for the ground/power planes.  How is this done properly?  I have done:

  1. set a "keep in" rectangle inset in from the board outline.
  2. Add: Frectangle on the ground layer
  3. Select the "0" net


However, when I do this, all of my through holes give me a DRC error: Thru Pin to Shape Spacing

I also get an error for the keep in layer: Shape to Route Keepin Spacing

Parents
Reply
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.