Stats

Locked Locked
Replies 4
Subscribers 166
Views 16024
Members are here 0

Hole to Line spacing not working

Constraints:

Constraints are enabled:

But some other constraint seems to be active:

The pink color is the hole and the kind of shaded part in the middle is the pad, which will be removed by the drill. So it's a NPTH.

Any ideas why I can route as close as 0.15 mm to the hole and not 0.3 mm?

Padstack data:

type: Through Pin
units: mm
decimal places: 4

Hole data

geometry: Circle
size: 3.3000
offset: (0.0000, 0.0000)
tolerance: positive=0.0000 negative=0.0000
plating: Non-plated

Parents

jc teyssier over 6 years ago

17.2 ? Have a look to constraint mode and mechanical section: here is located a check box to use spacing constraint set values instead of provided values in this section.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

jc teyssier over 6 years ago

17.2 ? Have a look to constraint mode and mechanical section: here is located a check box to use spacing constraint set values instead of provided values in this section.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.