I was wondering if anyone can guide me in the right direction.
I'm trying to make it so I can set the bottom SMD pin to TH distance when allegro starts up. This will need to be done to all files being opened.
I'm not familiar with writing skills, but I was wondering if anyone has ran into similar Skill file or at least guide me in the right direction.
I looked through some forum and it looks like I can use axlCmdRegister and axlTriggerSet commands to run the skill automatically once I have the skill file create.
I think this command is where I need to get started from, but I don't think it's that simple.
axlCNSSetSpacing("" TOP 'Thru Pin_SMD Pin .050 INCH)
Any help will be appreciated.
I can't seem to figure this out. I must be missing some steps here. My skill file name is TH_SMT.il and inside contains
(defun TH_SMT () axlCNSSetSpacing(nil "ETCH/BOTTOM" 'thrupin_smdpin axlMKSConvert(50 "mils") ))
This file seems to work just fine if I type in TH_SMT in the command line with allegro.ilinit calling out
I just can't seem to get it to run this automatically when I open the board.
I entered axlTriggerSet('open 'TH_SMT) in the allegro.ilinit file, but it does not work.
I also tried in in env file but it did not work either.
Any help would be appreciated.