Stats

  • Locked Locked
  • Replies 5
  • Subscribers 63
  • Views 16371
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to Model 40cm tline Using LMG Tool

saurabhsant

Hi

I want to model a 40cm FR4 line in Cadence using the parameters provided by manufacturer. I modelled a 4cm line using mtline model and LMG tool in it. A parameter of fmax is set to 18GHz as I have to operate at 16GHz. 

When I tried to model a 20cm TLine, I received error message that, the tool cannot model lines with more than 5 wavelengths long. 

Could somebody tell me how to model a 40cm transmission line in Cadence using given parameters? Which tool does this sort of modelling? 

Thanks in advance.

Parents

  • My guess is that you're using the standalone "lmg" tool (from the question). If so, this is obsolete and should not be used.

    Instead, place an instance of the "mtline" component from analogLib, and choose the Type of Input as being "Field Solver". Then enter the physical parameters about the line in the property fields for mtline - you can still press "Display Cross Section" to visualize it.

    The benefit of this approach is that the solver is run within the simulator, and generates the RLGC matrices (which are per-unit-length, and so do not have a length limitation). Because it's done in the simulator, you can parameterize the line's physical parameters, and sweep them, and so on.

    With lmg, you could choose to produce either a lumped model or RLGC parameters. The lumped model had to know the physical length of the line, because otherwise it couldn't lump it - and this had limitations on the length of the line.

    Since lmg has not been maintained, it will not have any of the improvements or fixes in the built-in field solver which is part of mtline. So you really should use that.

    Best Regards,

    Andrew.

Reply

  • My guess is that you're using the standalone "lmg" tool (from the question). If so, this is obsolete and should not be used.

    Instead, place an instance of the "mtline" component from analogLib, and choose the Type of Input as being "Field Solver". Then enter the physical parameters about the line in the property fields for mtline - you can still press "Display Cross Section" to visualize it.

    The benefit of this approach is that the solver is run within the simulator, and generates the RLGC matrices (which are per-unit-length, and so do not have a length limitation). Because it's done in the simulator, you can parameterize the line's physical parameters, and sweep them, and so on.

    With lmg, you could choose to produce either a lumped model or RLGC parameters. The lumped model had to know the physical length of the line, because otherwise it couldn't lump it - and this had limitations on the length of the line.

    Since lmg has not been maintained, it will not have any of the improvements or fixes in the built-in field solver which is part of mtline. So you really should use that.

    Best Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.