Stats

  • Locked Locked
  • Replies 3
  • Subscribers 63
  • Views 15613
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

About the parasitic reduction in Spectre Turbo mode

ycyang

Hi,

I am running a post-layout simulation of a frequency divider in Spectre Turbo mode. When I enable and disable the "parasitic reduction" option, the simulation results are slightly different.

For example, if the "parasitic reduction" option is enabled, the operating frequency can be as high as 3.6 GHz. While the "parasitic reduction" option is disabled, the highest operating frequency becomes 3.3 GHz.

According to the Designer's Guide Community Forum http://www.designers-guide.org/Forum/YaBB.pl?num=1291713886 the circuit behavior remains essentially unchanged by the parasitic reduction up to 30 GHz, if option "RF" is chosen.

However in my case the frequency of interest is below 5 GHz, why the simulation results differ when the "parasitic reduction" option is enabled and option "RF" is chosen?

Thanks 

 

Parents
  • Andrew Beckett

    If your clock is at (say) 4GHz (you didn't say), then you would have significant harmonics even at 30GHz. Those harmonics might be important - you didn't give any information about what you were measuring and what was different, and how different the results were. So very hard to tell.

    The idea is that the cut-off frequency specifies the frequency below which it tries to preserve poles in the transfer functions of the RC networks.

    Regards,

    Andrew.

Reply
  • Andrew Beckett

    If your clock is at (say) 4GHz (you didn't say), then you would have significant harmonics even at 30GHz. Those harmonics might be important - you didn't give any information about what you were measuring and what was different, and how different the results were. So very hard to tell.

    The idea is that the cut-off frequency specifies the frequency below which it tries to preserve poles in the transfer functions of the RC networks.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.