Stats

  • Locked Locked
  • Replies 7
  • Subscribers 63
  • Views 16765
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Interfacing Spectre Parametric analysis result to MATLAB in command.

RFQuery

Dear All,

I was trying to plot the swept DC operating points of a MOS transitor with changing some parameters of the MOS. Like I swept the Vgs of MOS and did the parametirc run on 'Length' of the MOS. (Prametric run was done by going to Tools-->Parametric Analysis).

I was able to plot the parametrically swept curves by using Result Browser of ADE like ploting Id vs Vgs for different length of the transistors. But I want to plot them in MATLAB and further process the DC operating point data. I was not able to do this in MATLAB using cdsrr() command.

However using the way Mr Andrew said in this link  www.cadence.com/.../1307561.aspx, I was able to plot in MATLAB. So how one can trnasport the data to MATLAB if he runs parametric analysis in ADE.

Kind regards

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.