I simulate a VCO in my design and export results to MATLAB using the cds_srr() function. Now, to account for mismatches, I want to run a Monte Carlo simulation (only 1 run).
1) Is there any change in the way I export the data into MATLAB after a MC run?
2) I do not want separate mismatch statistics. Just normal tran results with mismatches accounted for. Is this the final data that is stored? Or are they separate?
3) I did not select "Save data to allow family plots" thinking I have only 1 MC run and so it is not needed. Do I have to select it even for a single run?
If you are going to want to get the raw data into Matlab, you'll need to save the family data, because otherwise the results get discarded after each monte carlo interation (the scalar results are collected, but not the waveforms). You might find that you end up with a single run of data remaining, but you should not rely on that.
I don't understand your second question.