Stats

Locked Locked
Replies 5
Subscribers 63
Views 15211
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

tstab method in hb with mmsim12

Hello,

In the old versions of mmsim (now I'm using the v12) it was possible to set the method used by the initial transient (tstab). How can I set it in mmsim12?

In my simulations transient gives a correct result whereas hb/tstab predicts a strange behaviour that prevents the hb simulation to converge. Which are the default methods of the 2 analysis, tran and hb/tstab? Are there other different settings?

Thank you very much

Best regards

Aldo

Parents

Aldo2 over 11 years ago

Hi Andrew,
Yes, now I understand: I'm simulating the IP3 of a mixer but tstab make me see only LO leakage at the output.
Thank you
Best regards
Aldo
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Aldo2 over 11 years ago

Hi Andrew,
Yes, now I understand: I'm simulating the IP3 of a mixer but tstab make me see only LO leakage at the output.
Thank you
Best regards
Aldo
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.