Stats

  • Locked Locked
  • Replies 9
  • Subscribers 65
  • Views 27165
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to simulate the stability of a fully differential amplifier using the iprobe?

xxgenerall

The schematic is as follows. 

It is very useful tool used to simulate amplifiers' stability. Well, when simulating a fully differential amplifier, how to use the iprobe?

Thanks in advance. 

Parents
  • Frank Wiedmann

    xxgenerall said:

    Thank for all your help.

    I've checked the cmdmprobe, which circuit is same as the "diffprobe" subcircuit. Does diffstbprobe has the some circuit inside? Does it contain some iprobe inside?

    Thanks a lot. 

    In a few experiments I did some time ago, the diffstbprobe behaved exactly like a circuit consisting of two ideal_balun and two iprobe components from analogLib, with one iprobe connected between the d ports of the ideal_balun components, and the other iprobe connected between their c ports. This would be exactly the circuit described in reply #1 of http://www.designers-guide.org/Forum/YaBB.pl?num=1190707743 (3 years before the diffstbprobe was introduced in September 2010 in MMSIM 10.1).

Reply
  • Frank Wiedmann

    xxgenerall said:

    Thank for all your help.

    I've checked the cmdmprobe, which circuit is same as the "diffprobe" subcircuit. Does diffstbprobe has the some circuit inside? Does it contain some iprobe inside?

    Thanks a lot. 

    In a few experiments I did some time ago, the diffstbprobe behaved exactly like a circuit consisting of two ideal_balun and two iprobe components from analogLib, with one iprobe connected between the d ports of the ideal_balun components, and the other iprobe connected between their c ports. This would be exactly the circuit described in reply #1 of http://www.designers-guide.org/Forum/YaBB.pl?num=1190707743 (3 years before the diffstbprobe was introduced in September 2010 in MMSIM 10.1).

Children
  • Frank Wiedmann
    in reply to Frank Wiedmann
    Frank Wiedmann said:

    xxgenerall said:

    Thank for all your help.

    I've checked the cmdmprobe, which circuit is same as the "diffprobe" subcircuit. Does diffstbprobe has the some circuit inside? Does it contain some iprobe inside?

    Thanks a lot. 

    In a few experiments I did some time ago, the diffstbprobe behaved exactly like a circuit consisting of two ideal_balun and two iprobe components from analogLib, with one iprobe connected between the d ports of the ideal_balun components, and the other iprobe connected between their c ports. This would be exactly the circuit described in reply #1 of http://www.designers-guide.org/Forum/YaBB.pl?num=1190707743 (3 years before the diffstbprobe was introduced in September 2010 in MMSIM 10.1).

    To make this a little more clear, here is an image of this configuration:

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.