Stats

Locked Locked
Replies 2
Subscribers 63
Views 13989
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RF Front end Receiver

Hi, We are designing a RF Front end receiver in which we are proceeding with a PSS, PAC, etc analyses.....

1. We have plotted Conversion Gain Vs LO power by doing PSS followed by PAC analyses. So, can we plot the same CG by varying RF.

2. Can we plot Noise Figure Vs RF frequency.

Please, get me the valuable suggestions............

Parents

Tawna over 11 years ago

Hi Kiran1507,
If you are using MMSIM12.1.1 or 13.1, I recommend looking at Appendix A of the SpectreRF User Guide. There are a number of step by step examples that you may find useful.
Please note: To run the examples, you will need to obtain the gpdk180 PDK from http://support.cadence.com (it is no longer on http://pdk.cadence.com).
best regards,

Tawna
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Tawna over 11 years ago

Hi Kiran1507,
If you are using MMSIM12.1.1 or 13.1, I recommend looking at Appendix A of the SpectreRF User Guide. There are a number of step by step examples that you may find useful.
Please note: To run the examples, you will need to obtain the gpdk180 PDK from http://support.cadence.com (it is no longer on http://pdk.cadence.com).
best regards,

Tawna
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.