Stats

Locked Locked
Replies 1
Subscribers 63
Views 13623
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to select extracted view nets for Pnoise simulation

apskohli over 9 years ago

Hello,

I apologize if this isn't the right forum to ask this question, but I'm in a rush so I'm going to ask anyway.

When I'm using an extracted view net for running Pnoise simulation, ADE simply refuses to accept

the selected net (I'm able to select net in calibre view), while same works well for schematic view.

I'm guessing this has to do with hierarchy separator in the extracted view, I've tried renaming net and

such in the extracted view but no luck. Can anyone please suggest something that they might've used

successfully in the past. BTW I'm using IC5.10.41/spectre13.1.

Thanks,

Aman

Tawna over 9 years ago

Hi Aman,

If this is critical, please contact Customer Support . An AE can be assigned to your question and begin working on this. Cadence AEs who monitor this forum often do so on their own time.

best regards,

Tawna
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.