Stats

  • Locked Locked
  • Replies 8
  • Subscribers 63
  • Views 16858
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Envelope Simulation of a FM VCO.

Alli

Hi,

I'm having a VCO and trying to modulate the control voltage of the VCO and check the output spectrum.

The difference between the oscillator frequency and the modulation frequency is huge. Therefore, in order to make the simulations faster I tried to use the envelop simulation. As I understand and tested if the Fast env mode is off it would be really slow almost same as transient, to make the simulation faster I have to use the Fast env mode (level1 or level2), But it requires modulation source I/Q, though i don't have any I and Q channel. All I have it the control voltage of the VCO which is swept linearly between two values.

What I have to choose as the I/Q channel? (BTW, It requires both I and Q.)

If you have any hints to simulate FM VCO with envelop analysis please share it with me.

Thanks,

Ali

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.