Stats

  • Locked Locked
  • Replies 4
  • Subscribers 63
  • Views 17842
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to set input power in transient simulation?

MohanB

Dear all

I am currently working on RF rectifier which has an equivalent circuit as shown in fig below.

                                                                     

I have calculated Zin = 355-j1797 at a frequency of 953 MHz. I want to study the transient behaviour of the above network for Pin = 1 dBm. I am using the port component in analogLib to give the input power were the source resistance should be equal to load resistance to ensure 1 dBm is transferred. This works fine if Zin is real.

However, I am not getting Pin= 1 dBm for the above complex Zin. I specify Source resistance =355 and impedance = -1797. Could any one tell me if there is a problem with my source properties. Am I specifying the complex impedance correctly? I am running transient simulation.

Parents

  • When you set a power level(Amplitude dBm) or voltage level Amplitude (Vpk) in the port, the assumption is that the port is properly matched (both resistive and reactive).    

    Amplitude 1 (Vpk) - When you specify the voltage on a port, you are specifying the voltage when the port is properly terminated, and not the voltage on the internal voltage source. Thus, the voltage on the internal source is set to twice the value specified on the port.

    Amplitude 1 (dBm) -  is the amplitude of the first sinusoidal waveform, in dBm.The resistance for the dBm calculation is taken from the resistance of the port. The value specified is the power delivered into a matched load. 

    See the Spectre Circuit Simulator and APS Simulator RF Analysis User Guide, section on "analoglib components used in RF simulation".   The same would apply to transient.

    best regards,

    Tawna

Reply

  • When you set a power level(Amplitude dBm) or voltage level Amplitude (Vpk) in the port, the assumption is that the port is properly matched (both resistive and reactive).    

    Amplitude 1 (Vpk) - When you specify the voltage on a port, you are specifying the voltage when the port is properly terminated, and not the voltage on the internal voltage source. Thus, the voltage on the internal source is set to twice the value specified on the port.

    Amplitude 1 (dBm) -  is the amplitude of the first sinusoidal waveform, in dBm.The resistance for the dBm calculation is taken from the resistance of the port. The value specified is the power delivered into a matched load. 

    See the Spectre Circuit Simulator and APS Simulator RF Analysis User Guide, section on "analoglib components used in RF simulation".   The same would apply to transient.

    best regards,

    Tawna

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.