Stats

  • Locked Locked
  • Replies 4
  • Subscribers 63
  • Views 17842
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to set input power in transient simulation?

MohanB

Dear all

I am currently working on RF rectifier which has an equivalent circuit as shown in fig below.

                                                                     

I have calculated Zin = 355-j1797 at a frequency of 953 MHz. I want to study the transient behaviour of the above network for Pin = 1 dBm. I am using the port component in analogLib to give the input power were the source resistance should be equal to load resistance to ensure 1 dBm is transferred. This works fine if Zin is real.

However, I am not getting Pin= 1 dBm for the above complex Zin. I specify Source resistance =355 and impedance = -1797. Could any one tell me if there is a problem with my source properties. Am I specifying the complex impedance correctly? I am running transient simulation.

Parents

  • If the load is properly matched to the port as I mentioned in my previous post and you are seeing problems, please file a Case with Customer Support https://support.cadence.com  so an AE can look at this with R&D.

    best regards,

    Tawna

  • in reply to Tawna

    Hidden in the title of this thread is the fact that Mohan is running transient.

    Complex impedance (which can be specified per harmonic) is only used in hb analysis. It doesn't make sense in transient (and so is ignored) because the impedance cannot be complex across a range of frequencies (especially an unknown range which is what you have in transient) - that's not physically possible. With hb (via the "harmonic port" capability), you can specify a different complex impedance for each harmonic of the hb fundamental.

    Regards,

    Andrew.

Reply
  • in reply to Tawna

    Hidden in the title of this thread is the fact that Mohan is running transient.

    Complex impedance (which can be specified per harmonic) is only used in hb analysis. It doesn't make sense in transient (and so is ignored) because the impedance cannot be complex across a range of frequencies (especially an unknown range which is what you have in transient) - that's not physically possible. With hb (via the "harmonic port" capability), you can specify a different complex impedance for each harmonic of the hb fundamental.

    Regards,

    Andrew.

Children

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.