Stats

  • Locked Locked
  • Replies 1
  • Subscribers 63
  • Views 2892
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LVS can't identify layout inductor

popoYoHo

Hello Everyone,

My inductor in layout can't be identified in assura LVS. As shown below, it shows that inductor is unbound to any layout device. I also tried Calibre LVS, which also has the same problem. In calibre lvs, the report shows that missing inductor (bad device). Could anybody help me with it? Is my setting not correct? 

  • Presumably your LVS extraction rules don't have anything to recognise the inductor, or you're missing whatever layers are needed to recognise the inductor. Trying to debug this via a public forum is going to be hard as it probably needs knowledge of technology specific setup - so please contact customer support.

    Regards,

    Andrew

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.