Stats

Locked Locked
Replies 0
Subscribers 63
Views 13266
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

simultaneous bias on range of DC sweep

Hello, i am trying to bias the mosfets to be region=2 on a range on Vtest values as shown in the plot bellow.

I have defined DC sweep at ADEXL and made several parameters as shown bellow , i have defined global optimization, as shown in the end.I have here an optimization of DC sweep for several goals.

However there is "Learning process" in the optimization,it just following every combination of the parameters and not showing me any progress from which i can see that parameters needs to be increased in range so i will get closer to the goal.

What could be done the see the "best combination among the ranges?

Thanks

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.