Stats

  • Locked Locked
  • Replies 0
  • Subscribers 64
  • Views 15794
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Transimpedance amplifier design Cadence

RakeshPRG

Hi,
I am new to the circuit design and troubleshooting. My project is to design a trans-impedance amplifier using Cadence that can amplify a signal coming from a photodiode. I started out with the regulated cascode configuration as shown in the circuit below. I look at the frequency response using AC simulation and it looks like a high pass (/net 5). The results doesn ot show any gain (transient response), or expected low-pass roll-off in the AC response.

First thing, I looked into the operating regions of the MOSFETs and adjusted the input dc voltage of the Vsin to 0.5 to make sure that the T0, T1 mosfets are in saturation(checked this with the print->dc operating points). Beyond this point, I am not sure on how to proceed and interpret the results to make changes. Any help would be greatly appreciated.

Thanks,

-Rakesh.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.