Stats

Locked Locked
Replies 2
Subscribers 63
Views 8733
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

QPSS simulation

Hi everyone,

I am trying to use QPSS to simulate IIP3 of a mixer. It is ok when all source in my circuit are sin wave sources. But when i use a pulse source, the log file show that QPSS did not convergence.

Can you give me a guide to fix it ?

Thank you.

Parents

Andrew Beckett over 2 years ago

Not enough information - but why are you using QPSS? There's very few cases where QPSS is the best solution (nearly always you'd be better off using a multi-tone harmonic balance using the hb analysis).

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 2 years ago

Not enough information - but why are you using QPSS? There's very few cases where QPSS is the best solution (nearly always you'd be better off using a multi-tone harmonic balance using the hb analysis).

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.