Stats

Locked Locked
Replies 0
Subscribers 63
Views 867
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

EMX - Localised back etching

Do you know if it is possible to define localized back etching (LBE) in EMX? It should be associated to a layer which defines the holes done in the substrate. I've not found any reference for this in the .proc syntax.

--> Answer found. This is not possible because EMX considers the same dielectric in all x-y plane

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.