Stats

Locked Locked
Replies 1
Subscribers 63
Views 4864
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CPW ports

Hi, in EMX I'm trying to define the ports of a CPW line as suggested in one document of the support area (i.e. P1:Gright,Gleft). The EMX simulation works fine. When I generate the schematic, I get this:

Basically, the two ground ports of each end of the CPW are properly defined as a unique node (e.g. G2_1, G2_2).

However, when I try a simulation I get this error:

I hope you can help me. Thanks.

Andrew Beckett over 1 year ago

That's a bit odd. Have you modified the schematic_nport view since creating it? I would suggest opening the schematic_nport view and doing a check-and-save as the message suggests and seeing if that resolves it.

If not, please contact customer support.

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.