Stats

State Not Answered
Replies 4
Subscribers 44
Views 13162
Members are here 0

Placing from Capture 17.4-010

Hello,

I tried to place components from Capture in to the Orcad PCB Designer, but it does't work. I have activate the interactive option. It brings an error :

Error: No Placement Grid was found
ERROR(SPMHGE-458): Error see the message(s) above.

What I should do for the placing from capture?

Thank you

Parents

0 redwire over 5 years ago

Hmmm....placement grid is only needed when doing quickplace. If you use Place Manual you do not need the grid.

Which command are you running?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 redwire over 5 years ago

Hmmm....placement grid is only needed when doing quickplace. If you use Place Manual you do not need the grid.

Which command are you running?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.