Stats

  • State Not Answered
  • Replies 2
  • Subscribers 43
  • Views 4702
  • Members are here 0
More Content

Symbol created in ORCAD capture is not coming properly. The lines and shapes are showing puffed in schematic.

Eli Shein

I have created one MOSFET symbol in ORCAD Capture, the symbol is created fine. But if I place that part in schematic, the shapes and lines are showing puffed up. If I decrease the line width to the thinnest than its shows perfect in design.

Parents Reply Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.