Stats

Replies 10
Subscribers 161
Views 17881
Members are here 0

rotating groups of routed components and keeping clines connected

Lock2002 over 8 years ago

Is it possible to rotate a group of routed components without losing the connections? Allegro doesn't like to route anything other than 45 degrees cleanly, so I group the parts, route, then rotate, but the clines keep disconnecting.

Parents

Lock2002 over 8 years ago

It only does it with clines. It's not a problem if I create the connections with shapes, just clines.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Lock2002 over 8 years ago

It only does it with clines. It's not a problem if I create the connections with shapes, just clines.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

VanNhan over 5 years ago in reply to Lock2002

I met the same problem that some clines become disconnected . Have you found the solution or just updated manually ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Lock2002 over 5 years ago in reply to VanNhan

"derive connectivity" or manually.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
VanNhan over 5 years ago in reply to Lock2002

Thanks Lock2002
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.