Stats

  • Replies 2
  • Subscribers 161
  • Views 13810
  • Members are here 0
More Content

constraint region

masamasa

hello

i have a problem with the constraint region setting.

I set one region as l/s=50/50um and the other as l/s=10/10um as shown below

but when i connect the two clines over the two regions, the l/s=50/50um constraint takes over on region b as shown below.

is there a way to keep the l/s=50/50um constraint on region a and the l/s=10/10um constraint on region b over one net cline?

i set the physical and the spacing on the constraint manager as shown below. 

Parents

  • From here, it looks like you defined two constraint regions but they don't touch or overlap.  Outside the region, global netclass constraints take over.

    I believe it is intended to have a sub-region of the board where you have to drop to 0.07mm instead of 1mm to fan out a device.   Maybe you only need one region?

Reply

  • From here, it looks like you defined two constraint regions but they don't touch or overlap.  Outside the region, global netclass constraints take over.

    I believe it is intended to have a sub-region of the board where you have to drop to 0.07mm instead of 1mm to fan out a device.   Maybe you only need one region?

Children
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.