Stats

Replies 2
Subscribers 160
Views 13010
Members are here 0

Possible to set Pad Editor to use unit mm as defult?

Is there a way to set Pad Editor to always use mm as default? I am always making the footprints in mm but sometimes I forget to set it at startup of pad editor and then have to go back and redo the pads. Would be good if its possible to set mm to be used as default.

Thanks.

Parents

steve over 5 years ago

Yes, open PCB Editor and go to Setup>User Preferences>drawing>new_design and set the padstack_editor_new_units and accuracy to suit
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

steve over 5 years ago

Yes, open PCB Editor and go to Setup>User Preferences>drawing>new_design and set the padstack_editor_new_units and accuracy to suit
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Magnetcore over 5 years ago in reply to steve

Great thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.