Stats

  • Replies 7
  • Subscribers 158
  • Views 18356
  • Members are here 0
More Content

Via on SMT pin DRC

archive

Same net DRC off. How could we avoid that via on pin problem. Or how could we identify the DRC.


Originally posted in cdnusers.org by Vignesh
Parents
  • archive

    Just to make sure... Please verify:

    1)
    Under your Physical Rules, ""Set DRC modes..."" button, you have ""Pad/Pad direct connect"" set to ""Always"" for the 'proper' constraint set?

    2)
    Under Physical Rules, ""Set values..."" button, you have ""Pad/pad direct connect"" set to ""Not Allowed"" for the 'proper' constraint set?

    If so, it would probably be best to open a Service Request with Cadence Support to look at your design.


    Originally posted in cdnusers.org by Padmin
Reply
  • archive

    Just to make sure... Please verify:

    1)
    Under your Physical Rules, ""Set DRC modes..."" button, you have ""Pad/Pad direct connect"" set to ""Always"" for the 'proper' constraint set?

    2)
    Under Physical Rules, ""Set values..."" button, you have ""Pad/pad direct connect"" set to ""Not Allowed"" for the 'proper' constraint set?

    If so, it would probably be best to open a Service Request with Cadence Support to look at your design.


    Originally posted in cdnusers.org by Padmin
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.