Stats

Replies 2
Subscribers 160
Views 14788
Members are here 0

How to create exception shape area from dynamic shape?

Hi All,

normally I use the dynamic shape when we place the copper on the board with KEEPIN ROUTE prop.

but how can I set the exception area from dynamic copper area?

for instance, I want to except that area (red hatch below) from dynamic copper, but I can't control the KEEPIN ROUTE area, because it also included the clines as well

I only want to except the shape GND area on that red zone

regards,

DavidJHutchins over 4 years ago

Try adding the properties ROUTES_ALLOWED and VIAS_ALLOWED to that specific keepout shape
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ichliebedich over 4 years ago in reply to DavidJHutchins

Do I need to add dummy net for adding ROUTES_ALLOWED and VIAS_ALLOWED prop. on there?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.