Stats

  • Replies 3
  • Subscribers 167
  • Views 3450
  • Members are here 0
More Content

Some holes don't show up in .DRL artwork

jtw385

Hi,

I've just completed a design in PCB Designer 17.4 that when viewed using gerbv is flawless except for the fact that four through-holes won't show up in the .drl artwork, each corresponding to one of four pins on the same connector. These pins are connected to a ground plane on layer 2 (four layer board) and all other through holes on the board are displayed normally--even two holes on the same connector that aren't associated with these four pins. I've inspected the pad and it correctly shows oblong slotted holes on each pin. What gives?

Thanks,

John

Parents Reply Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.