Stats

Replies 3
Subscribers 161
Views 12695
Members are here 0

Identifying Overlapping Vias in PCB Editor

I've had a couple projects now where the contract manufacturer has come back to me saying there are overlapping vias in the drill file. I must be double-clicking a little too fast when adding vias?

Is there any way these overlapping vias can be detected in OrCAD PCB Editor? I am using OrCAD PCB Designer Professional 17.4-2019 S016.

Parents

steve over 4 years ago

There is a Duplicate drill DRC that can be enabled. Look at Setup - Constraint Modes - Design - General and make sure the DRC is enabled.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel

Reply

steve over 4 years ago

There is a Duplicate drill DRC that can be enabled. Look at Setup - Constraint Modes - Design - General and make sure the DRC is enabled.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel

Children

Gipper over 4 years ago in reply to steve

Found it. It was disabled. Thank you!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.