Stats

State Suggested Answer
Replies 3
Answers 1
Subscribers 161
Views 3311
Members are here 0

move layout to coordinates of 0,0

I imported a DXF file but it was placed in middle of somewhere . I would like to move the left corner bottom to the coordinates of 0,0. Is there an easy way to do it?
The corner is also round shape, it's is very difficult to move it manually.

Parents

0 MaxS over 3 years ago

Usually, I place a circular shape at the point I want to be the design origin. Then look at coordinates or the center of this shape using the Show Element command. Then I go to Setup-->Design Parameters -->Design Tab and put these numbers in Move Origin fields. Then delete the shape.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 MaxS over 3 years ago

Usually, I place a circular shape at the point I want to be the design origin. Then look at coordinates or the center of this shape using the Show Element command. Then I go to Setup-->Design Parameters -->Design Tab and put these numbers in Move Origin fields. Then delete the shape.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.